.To charge using a USB connection to a computer

The battery loaded in the camera is charged whenever the camera is connected directly to a computer with the USB cable.

Depending on the setup of your computer, you may not be able to charge the camera’s battery over a USB connection. If this happens, use of the USB-AC adaptor that comes with the camera is recommended.

1.Turn off the camera.

Check to make sure that the LCD monitor is blank. If it isn’t, press the POWER button to turn off the camera.

IMPORTANT!

If you connect the camera to a computer for the first time after you purchase it while the camera is turned on, the computer will enter a camera recognition operation. If this happens, perform the procedure on page 67. After the computer recognizes the camera, turn off the camera.

2.With your computer turned on, connect the camera to it.

The LED indicator should flash green, indicating that charging has started.

The LED indicator will go out when charging is complete.

It takes about 150 minutes to achieve a full charge. Charging may take longer depending on charging conditions.

USB port

USB cable

(included with camera)

 

Large connector

 

USB port

 

Small connector

Making sure that the mark on the USB cable connector is towards the lens side, connect the cable to the camera.

14

Getting Started