Troubleshooting
Indicators
Indicators keep you informed about the current operational status of the projector. The following shows what the indicators look like when operation is normal.
When the indicators appear | It means this: | |
like this: | ||
| ||
|
|
POWER/ | LIGHT | TEMP | You have just plugged the AC power cord into a power outlet. Wait |
STANDBY |
|
| until the projector enters the standby state (see below) before trying |
|
|
| |
z | z | z | to turn on power. |
Amber | Amber | Amber |
|
|
|
|
|
z | c | c | Standby state: The AC power cord is plugged in and the projector is |
Amber |
|
| in standby. |
|
|
|
|
| z | z | Projector is warming up after being turned on. |
Green | Amber | Amber |
|
|
|
|
|
z | c | c | Projector is on and standing by for use. |
Green |
|
|
|
|
|
|
|
| c | c | Projector is performing internal power down processes. |
Amber |
|
|
|
|
|
|
|
z | z | c | “On (Auto)” or “On (Manual)” is selected for the projector’s Eco Mode |
Green | Green |
| (page 23) setting. |
|
|
| |
z : Lit | : Flashing | c : Unlit |
When a warning message appears on the projection screen, or when the POWER/STANDBY, LIGHT, and TEMP indicators are lit or flashing in a pattern other than those shown above, it means that a projector error has occurred. For details, see “Error Indicators and Warning Messages” (below).
Error Indicators and Warning Messages
Warning messages and indicators let you know what the problem is when a projector error occurs. When an error occurs, wait until the fan stops before unplugging the AC power cord. If you unplug the AC power cord while the fan is still operating, an error may occur when you plug the AC power cord back in.
Indicator/Error Message | Description and Required Action | ||
POWER | : Green steady | The projector’s internal temperature is very high. Press the [ESC] key to | |
LIGHT | : – | clear the warning message and perform the following steps. | |
1 Check for any blocking of the projector’s intake vents and exhaust | |||
TEMP | : – | ||
vents, and make sure that there is sufficient space around the | |||
Message | : Internal temperature is too | projector. See “Setup Precautions” (page 10). | |
| high. Check projector air | 2 If there is dust accumulated around the intake vents and/or exhaust | |
| vents for blockage. | vents, turn off the projector and remove it. See “Cleaning the | |
|
| Projector” (page 43). | |
|
|
|
44