Back Terminals

Depending on your projector, the orientation of the ports and terminals may be opposite from those shown in the illustration below. Functions and use of the ports and terminals are the same as described in this manual, regardless of their orientation.

COMPUTER terminal

Serial port*

 

AV terminal

Speaker

Remote control signal receiver

 

HDMI port

Intake vents

USB port

Power connector

(XJ-A146/XJ-A246/XJ-A256 only)

Anti-theft lock hole

*This serial port is for connecting a separately available special cable (YK-5) to control the projector from a computer.

Loading Remote Controller Batteries

Important!

Be sure to use alkaline batteries only.

*Caution

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

 

 

 

1. Open the battery cover on the back of the remote controller.

2. Load two new batteries into the case, making sure that their positive

(+)and negative (–) ends are facing correctly.

3. Close the battery cover on the back of the remote controller.

Replacing Remote Controller Batteries

Open the battery cover on the back of the remote controller, replace the old batteries with new ones, and then close the battery cover.

C

9