Installation
IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY A SUITABLY QUALIFIED PERSON. WE RECOMMEND THAT YOU SEEK THE HELP OF ANOTHER INDIVIDUAL WHEN INSTALLING THIS PRODUCT
1.Slide the base unit into the housing ensuring the dimensions are correct as per figure 1.
2.Fix the base unit in place by attaching the 10 screws in to
the holes as shown in figure 2 and figure 3. If the sides of the base are not flush with the sides of the housing, then use the shims provided.
3.Push the runners fully closed on the base unit.
4.Connect the plug to the plug socket. This must be accessible after the appliance has been installed.
5.Using an appropriate supply pipe, connect one end of the
hose to the threaded inlet of the valve on the dispenser, located at the rear of the appliance.
6.Insert the flow restrictor between two rubber washers, then connect the other end of the pipe to the mains water supply (drinking water only)
7.Insert the appliance into the housing, ensuring that the runners on the machine are located in the runners on the base unit. Then slide the appliance fully into the housing.
542
320 min
320
fig. 1
fig. 2
fig. 3
11
