Troubleshooting
The coffee machine does not | The machine is not fully back in its | Push the coffee machine back | |
switch on | housing. | fully. | |
|
|
| |
| There is a problem with the electricity | Check that the mains supply | |
| supply. | has not been switched off. | |
|
| Check that the fuse in the spur | |
|
| has not blown. | |
|
|
| |
The coffee will not dispense or | The coffee grind is too fine. | Adjust the grind to be coarser. | |
dispenses only in slow drips |
|
| |
There is not enough water in the water | Fill the water tank or check | ||
| |||
| tank | there is no fault with the mains | |
|
| water supply. | |
|
|
| |
| The internal pipes are obstructed |
| |
|
|
| |
The coffee dispenses too fast and is | The coffee grind is too coarse. | Adjust the grind to be finer. | |
not creamy |
|
| |
The coffee is too old | Replace the coffee beans with | ||
| |||
|
| fresh beans | |
|
|
| |
| Coffee blend | Change the coffee beans for | |
|
| those appropriate for use. | |
|
|
| |
The pump makes a loud noise when | There is not enough water in the water | Fill the water tank or check | |
dispensing coffee | tank | there is no fault with the mains | |
|
| water supply. | |
|
|
| |
| The coffee grind is too coarse so the | Adjust the grind to be finer. | |
| pressure in the filter holder is too low. |
| |
|
|
| |
Milk froth does not form |
| Check the flow of steam is | |
|
| suitable | |
|
|
|
The coffee machine is equipped with an
Machine | Display shows | Solution |
on/off |
|
|
|
|
|
OFF | CLOSE TAP | Close the steam control knob |
|
|
|
OFF | DESCALING | Descale the coffee machine |
|
|
|
ON | TECHNICAL SERVICE | Before calling CDA Customer Care, first try pulling the coffee machine out and |
|
| pushing it back in fully. |
|
|
|
ON | WATER PRESSURE | Check the water tank is full and then open the water dispensing tap, letting |
|
| water out of the steam nozzle until the display stops flashing. This allows the |
|
| system to refill. |
|
|
|
ON | GRINDER | Check the grinder for any foreign bodies (e.g. stones or impurities). Fully turn |
|
| the grind adjustment control knob |
|
| by running the grinder for a few seconds. Once this is complete, return the |
|
| grind adjustment control knob to its previous position. |
|
|
|
10