CDA CW493 BL/WH/SS manual Adjustment of Back Feet a, How to use water-proof plastic

Assembly Instructions for Integrated Dishwasher

GB

Adjustment of Back Feet (Fig.6A)

Insert the appliance in the cutout and then adjust the height of the machine using the screws located at the bottom front .Use a screwdriver to turn the screws in a clockwise direction to raise the dishwasher and in an anticlockwise direction lower it.

How to use water-proof plastic

Firstly take off the water-proof plastic from the sticker with the appliance (see￿I=Fig.9). Secondly stick it on the bottom of the kitchen board (see￿I=Fig.9). All of this can avoid humidity in the kitchen.

Adjusting the Door Springs (Fig.6B)

The door must be perfectly balanced. In the factory , the tension of the springs is regulated to ensure that the door is perfectly balanced when light wood door panels are mounted on the door. If heavier, solid wood door panels are used, the door can be balanced by simply turning the two screws (both screws must be turned the same amount) located on the top part of the machine.

Installation of Continuous Base Moulding

Position the washing machine in the cut-out in the kitchen cabinet: 1￿Install the continuous base moulding , following the

manufacturer’s instructions .

2￿Slowly open the door of the dishwasher to check to see if the door strikes or rubs against the base moulding.

3￿If so, rest the bottom edge of the panel on the base moulding and mark the part to be cut. Leave at least 3mm of the play between the panel and the base moulding to allow for the door to rotate freely (Fig.7).

4￿Remove the base moulding and trim it as needed,protecting the surface that has been cut with a paint or similar wood finish (Fig.7)

5￿Install the base moulding again (Fig.8).

Positioning the Unit within the Cutout (Fig.10)

Push the dishwasher into the cutout opening and turn the feet to make it level and to adjust for height so that the crosspiece (A) for fastening it in place located on the top part of the machine (Fig.10) comes into contact with the counter .Align the door panel mounted on the dishwasher with the doors on the adjacent cabi- net (2).

Important:

The dishwasher must absolutely be fastened to the counter top to prevent the machine from tipping when the loaded dish racks are pulled out.

Notice:

If power screwdrivers are used to make the adjustment, make the final adjustment manually with a normal screwdriver.

.12.