CDA HCC662 manual How to Install the Hob, How to install the hob

How to Install the Hob

How to install the hob:
Overall dimensions of the hob:	Width: 580mm Depth: 510mm
Worktop cut-out dimensions:	Width: 560mm Depth: 490mm

1.Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear wall or splashback is 50mm.

2.Position the hob seal, as shown in Fig.6, ensuring that the ends meet without overlapping. Do not use silicone type sealant.

3.Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in Fig.7. Remove any excess sealant after tightening the brackets. Do not over-tighten the fixing brackets.

	60mm	(600mm minimum)
	480mm
	400mm	650mm
	560mm
190mm	190mm
Fig.4	Fig.5
	3cm	4cm
Fig.6	Fig.7

9