Failure Code and Troubleshooting
Problem |
| Possible cause | ||
|
|
|
| |
| Check the plug, fuse and circuit breakers of the mains supply | |||
|
| The water tap is turned off | ||
The programme will not start |
| The dishwasher door is not fully closed | ||
| The water inlet filter or the machine filters are blocked | |||
|
|
|
| |
|
|
|
| |
Water remains inside the dishwasher at the end of the |
| The water drain hose is blocked or kinked. | ||
| The filters are blocked | |||
programme |
| |||
|
|
| ||
|
|
|
| |
|
| Power failure | ||
The dishwasher stops in the middle of a programme |
| Water inlet failure | ||
|
| Programme is on standby | ||
|
|
|
| |
| Poor loading of dishes hinders wash performance. | |||
|
| Insufficient detergent added | ||
Wash performance is of a low standard |
| Inappropriate wash programme selected | ||
| Spray arm blocked | |||
|
| |||
|
| Filters clogged or incorrectly fitted | ||
|
| Water drain pump blocked | ||
|
|
|
| |
|
| Insufficient detergent added | ||
|
| Rinse aid setting is too low | ||
White stains on the dishes |
| Insufficient dishwasher salt added | ||
|
| Water softener setting is too low | ||
| Salt compartment cap not completely closed | |||
|
|
|
| |
The dishes are not completely dry at the end | A programme without a drying stage was selected | |||
| Rinse aid setting is too low | |||
of the programme |
| |||
Dishes unloaded too soon (allow time for drying) | ||||
| ||||
|
|
|
| |
| Different sets of cutlery should be kept separate | |||
There are rust stains on the dishes | Too much salt (Water softener setting is too high) | |||
Salt compartment cap not completely closed | ||||
| ||||
| Poor appliance earth (check mains electrical supply) | |||
The door is not opening or closing properly
Door tension not correctly adjusted for the décor door
12
