Attaching the R.A. Slow Motion Knob

With the mount securely in place, you are ready to attach some of the accessories (the telescope tube will be added last). Start with the Right Ascension (R.A.) slow motion knob. The R.A. slow motion knob allows you to make fine pointing adjustments in the direction the telescope is aiming (once it is attached to the mount). To install the knob:

1. Locate the hard plastic shell under the R.A. shafts.

2. Remove either of the two oval tabs by pulling tightly.

3. Line up the flat area on the inner portion of the R.A. slow motion knob with the flat area on the R.A. shaft..

4. Slide the R.A. slow motion knob onto the R.A. shaft.

The knob is a tension fit, so sliding it on holds it in place. As mentioned above, there are two R.A. shafts, one on either side of the mount. It makes no difference which shaft you use since both work the same. Use whichever one you find more convenient. If, after a few observing sessions, you find the R.A. slow motion knob is more accessible from the other side, pull firmly to remove the knob, then install it on the opposite side.

Mounting Platform

 

Telescope

Mounting Platform

Mounting Screw

 

Safety Screw

DEC Lock

 

Lever

DEC Slow Motion

KnobRA Lock

Lever

Declination Setting

Circle

R.A. Slow Motion

R.A. SettingKnob

Circle

Polar Housing

Cover

Altitude Adjustment

Control

Azimuth Adjustment

Controls

Figure 2-5

TheCG-5EquatorialMount

14 • The C150-HD

Page 14
Image 14
Celestron 31056, 31058 instruction manual Attaching the R.A. Slow Motion Knob