Floor Loop Handle, Floor Loop Opening Handle

1To remove floorboard:

•Unfasten attachment straps.

•Remove floorboard and set aside.

2Lift Floor Handle, rotate counterclockwise to unlock floor and pull up, approximately 45.7 cm (18 inches).

4Gather Playard frame together while pulling up on Floor Loop.

5Wrap floorboard around Playard

frame with padding facing in.

NOTE: Floorboard Handle MUST be aligned with wheels as shown.

6Secure Attachment Straps by threading through loops on end of floorboard and

folding back onto itself.

Floor Loop

Floor

Handle

3To fold top rails:

•Pull up on top rail slightly.

•Squeeze Release Button on bottom of top rail and push rail down. (Release buttons are identified by printed arrows.)

Repeat for other sides.

NOTE:

•If rails are difficult to unlock, raise center of floor higher and

squeeze Release Button again.

•If only one side of rail folds, squeeze Release Button again to fully fold.

NOTE: Make sure floorboard is positioned above wheels.

7Position travel bag over Playard so Handle comes through

Opening in side of bag.

Pull travel bag over Playard.

Pull Floor Loop through opening on top of travel bag.

NOTE: To prevent rubbing, make sure travel bag is positioned above wheels.