ASSEMBLY and USE continued
3 With vinyl side facing up, | |
insert two (2) |
|
on changer into | |
in bassinet and push down |
|
to secure. |
|
1 Lay canopy on flat surface.
2 Unfold rods and insert fiber glass ends into aluminum ends.
4Push Triangular Tabs into TriangularHoles in Playard corners.
5Secure changer to Playard:
Triangular
Tab 
Triangular 
Hole 
NOTE: There are three
(3)sections of each rod that must be extended.
3Slide rod completely into canopy fabric.
• Pass Attachment Strap through opening in corner of side panel of Playard.
• Fasten strap to outside of Playard.
Repeat for other strap.
Attachment
Strap
6Place storage pocket flap over
side of Playard.
NOTE: DO NOT place supplies weighing more than 2.3 kg (5 lbs.) in storage pocket.
Changer is now ready for use.
Canopy
Canopy can only be used with Playard.
DO NOT use canopy when using bassinet or changer.
WARNING
Avoid serious injury or death:
Temperature inside Playard with canopy can be higher than outside:
•DO NOT cover mesh. Keep well ventilated.
•Keep out of direct sun.
•Remove child from Playard before child becomes overheated.
Repeat for other rod.
4Pull end of Sleeve over rod and
release rod.
Repeat for other rod.
Sleeve
5Set canopy over Playard and
insert canopy tabs into
curved slots of Playard corners.
6 Secure canopy bottom around | Attachment |
Playard corners using | |
Attachment Strips. | Strips |
6
