ASSEMBLY and USE continued
5 Insert one side of floorboard | |
under Pocket on side of |
|
bassinet. |
|
Pockets
6Pull Pocket down over
floorboard to hold floorboard in place.
Repeat steps 5 and 6 for other side of floorboard.
7Push down on center of floorboard to flatten.
Bassinet assembly is now complete.
•Bassinet can be used with or without changer.
•Bassinet can be used with or without Playard.
To use bassinet with Playard:
1Place bassinet in Playard so that
hooks go over long rails with
To use bassinet without Playard:
WARNING
Prevent falls and suffocation:
•Use only on a surface that is flat, level and stable.
•Keep bassinet away from surface edges.
1Set bassinet on flat and stable surface that will keep floorboard level so child will not roll into corner or side of bassinet resulting in breathing difficulties.
2Keep at least 30.5 cm (12 inches) away from surface edges and stay within reach of child. Child’s wiggling and rocking may cause bassinet to move and possibly fall off surfaces.
Changer
Changer can only be used when bassinet is installed in Playard.
WARNING
Avoid serious injury or death:
•Always use restraint belt to prevent falls.
•Use with infant who weighs less than 8.2 kg (18 lbs.) and is less than 63.5 cm (25 inches) tall.
•Discontinue use of changer if infant can push up on hands and knees or sit unassisted.
•DO NOT carry changer with infant in it.
NOTE:
“T-Slots”
2Secure bassinet to Playard:
• Pass Attachment Strap through opening in corner of side panel of Playard.
• Fasten strap to outside of Playard.
Repeat for other strap.
Attachment
Strap
Bassinet is now ready for use with Playard.
1Lay changer on flat surface.
2Grasp middle of each long side and gently pull apart until short sides “click” and lock in place.
NOTE: Make sure changer sides are fully extended and locked.
Triangular T-Fitting Tab
5
