7/30/08 | 11:34 AM | Page 7 | |
SPECIFICATIONS |
|
|
|
SETUP |
| CONNECTIONS |
|
|
|
Mode Select
Stereo Mode
In stereo mode, both channels operate independently with individ- ual input gain controls. Signal at channel 1’s input produces out- put at channel 1, while signal at channel 2’s input produces out- put at channel 2’s output. Recommended minimum nominal load impedance for stereo operation is 2 ohms per channel.
Parallel Mode
When set to Parallel mode, a signal applied to channel 1’s input will be amplified and appear at outputs for both channel 1 & 2. The parallel mode is well suited for applications in which driving two speakers with the same signal but with separate amplifica- tion. The ‘Channel1’ and ‘Channle 2’ input gain controls individu- ally control the out put level on channels 1 and 2.
Bridged Mono Mode
Bridged mono mode straps both amplifier channels together to make a very powerful,
Signal is applied to the channel 1 input only and channel 1 input gain control is used to adjust signal level. The input gain control belonging to channel 2 are not used.
Note : Bridged mono mode is to be used only when the
iting.
Use extreme caution when operating the amplifier in Bridged Mono Mode. Never ground either side of the speaker cable; the speaker load must “ float “ away from the
Stereo Mode
Parallel Mode
Bridged Mono Mode
10 |
7