Operation of Your Opener

Activate the opener with any of the following devices:

1.The Remote Control Transmitter. Hold push button down until the door starts to move.

2.The Door Control. Hold button/push bar down until the door starts to move.

3.The Outside Keylock or Keyless Entry. (See Accessories)

When the Opener is Activated:

WARNING

Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when the door is fully closed.

1.If open, the door will close. If closed, the door will open.

2.If closing, the door will reverse.

3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).

4.If the door has been stopped in a partially open position, it will close.

5.If obstructed while closing, the door will reverse.

6.If obstructed while opening, the door will stop.

7.The garage door will reverse in the closing cycle when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.

Trolley Release Arm

Trolley

NOTICE

Manual Release

Handle (Pull Down)

Manual disconnect

position

To open the door manually:

The door should be fully closed if possible. Pull down on the manual release handle and lift the door manually. To reconnect the door to the opener, press the Door Control button/push bar.

If the sensor is not installed, or is not aligned correctly, the door won't close from any remote control transmitter. You can close the door with the Door Control, the Outside Keylock, or the Keyless Entry, however, if you press and hold the button/push bar until down travel is complete. If you release the button/push bar too soon, the door will reverse.

The opener lights will blink for 5 seconds when the safety reversing sensor causes the door to reverse.

Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. They will turn off automatically after 4-1/2 minutes or provide constant light when the Light feature is activated. Bulb size is 75 watts maximum.

The lockout feature prevents the trolley from reconnecting auto- matically. Pull the manual release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the Lockout Feature, pull the manual handle straight down. The trolley will reconnect on the next UP or DOWN operation.

Trolley Release Arm

Trolley

NOTICE

Manual Release Handle

(Pull Down & Back

Towards Opener)

Lockout position

Operation of the Door Controls

Lighted Door Control Button;

Lock Feature – Door Control Panel: The Lock

Lighted Push Bar – Door Control Panel: Press to

feature is designed to prevent operation of the door

open or close the door.

from remote controls. However, the door will open

Press again to reverse the door during the closing

and close from the Door Control push bar, the

Outside Keylock and the Keyless Entry Accessories.

cycle or to stop the door while it's opening.

To Activate: Press and hold the Lock button for 2

Light Feature – Door Control Panel: Press the

seconds. The push bar light will flash as long as the

Light button. If the opener light is off, it will turn on.

Lock feature is on.

If the opener light is on, (even in the 4-1/2 minute

To turn off: Press and hold the Lock button again

automatic cycle) it will turn off.

for 2 seconds. The push bar light will stop flashing.

But if you use the Light button to turn the light(s) on

Normal operation will resume. The Lock feature will

and then activate the opener, the light(s) will turn off

also turn off whenever the "Smart" button on the

after 4-1/2 minutes.

opener end panel is activated.

The Light button will not control the opener lights

 

when the door is in motion.

 

32