Having a Problem?
Situation | Probable Cause & Solution |
The opener doesn't operate from either the door control or the remote control:
1.Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled by a wall switch.)
2.Have you disabled all door locks? Review installation instruction warnings on Page 11.
3.Is there a
4.The garage door spring may be broken. Have it replaced.
5.Repeated operation may have tripped the overload protector in the motor. Wait 15 minutes. Try again.
Opener operates from remote control, but not from door control:
1.Is the door control push bar lit? If not, Remove the bell wire from the opener terminal screws. Short the red and white terminals by touching both terminals at the same time with a piece of wire. If the opener runs, check for a faulty wire connection at the door control, a short under the staples, or a broken wire.
2.Are the wiring connections correct? Review Step 6, page 18.
The door operates from the door control, but not from the remote control:
1.If your model has the Lock feature, turn it off.
2.Is the wall push button flashing? Your opener needs to
3.Does the battery test light glow when the remote control push button is pressed? If not, replace the battery.
4.Program the receiver to match the remote control code.
5.Repeat the receiver programming procedure with all remote controls.
The remote control | 1. | Check the battery test light. If the light is dim, replace the battery. |
has short range: | 2. | Change the location of the remote control in your car. |
| 3. | Check to be sure the antenna on the side or back panel of the opener extends fully |
|
| downward. |
| 4. Some installations may have shorter range due to a metal door, foil backed |
| insulation, or metal garage siding. |
|
|
Opener noise is | If operational noise is a problem because of proximity of the opener to the living |
disturbing in living | quarters, the Vibration Isolator Kit 41A3263 can be installed. This kit was designed to |
quarters of home: | minimize vibration to the house and is easy to install. |
The garage door opens and closes by itself:
1.Be sure that all remote control push buttons and battery indicator lights are off.
2.Remove the bell wire from the door control terminals and operate from the remote control only. If this solves the problem, the door control is faulty (replace), or there is an intermittent short on the wire between the door control and the opener.
The door doesn't | 1. | If the door has been working properly but now doesn't open all the way, increase the |
open completely: |
| up force. See page 29. |
| 2. | Is something obstructing the door? Remove the obstruction or repair the door. |
| 3. | If door opens at least 5 feet, the travel limits may need to be increased. One turn |
|
| equals 2 inches of travel. See page 28. |
Repeat the safety reverse test after the adjustment is complete.
The door stops but doesn't close completely:
Review the travel limits adjustment procedures on page 28.
Repeat the safety reverse test after any adjustment of door arm length, close force or down limit.
34