Operation of Your Opener
Activate the opener with any of the following:
•The Remote Control Transmitter. Hold push button down until the door starts to move.
•The Door Control. Hold push bar down until the door starts to move.
•The Outside Keylock or Keyless Entry System. (See Accessories)
When the opener is activated with the safety reversing sensor installed and correctly aligned:
WARNING
Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when the door is fully closed.
1.If open, the door will close. If closed, the door will open.
2.If closing, the door will reverse.
3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).
4.If the door has been stopped in a partially open position, it will close.
5.If obstructed while closing, the door will reverse.
6.If obstructed while opening, the door will stop.
7.The garage door will reverse in the closing cycle when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.
Trolley 
Release Arm
Trolley
NOTICE
Manual
Release Handle
(Pull Down)
Manual disconnect
position
To open the door manually:
The door should be fully closed if possible. Pull down on the red manual release handle and lift the door manually.
To reconnect the door to the opener, press the Door Control push bar.
If the sensor is not installed, or is not aligned correctly, the door won't close from any remote transmitter. You can close the door with the Door Control, the Outside Keylock, or Keyless Entry, however, if you activate them until down travel is complete. If you release them too soon, the door will reverse.
The opener lights will blink for 5 seconds when the safety reversing sensor causes the door to reverse.
The Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. It will turn off automatically after
The lockout feature prevents the trolley from reconnecting auto- matically. Pull the red manual release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lockout feature, pull the manual handle straight down. The trolley will reconnect on the next UP or DOWN operation.
Trolley 
Release Arm
Trolley
NOTICE
Manual
Release Handle
(Pull Down & Back
Towards Opener)
Lockout position
Operation of the Door Controls (both are not included with all models)
Lighted Door Control Button: | Lock Feature - Door Control Panel: The Lock | |
Lighted Push Bar - Door Control Panel: Press to | feature is designed to prevent operation of the door | |
open or close the door. | from remote controls. However, the door will open | |
Press again to reverse the door during the closing | and close from the Door Control push bar, the | |
Outside Keylock and the Keyless Entry Accessories. | ||
cycle or to stop the door while it's opening. | ||
To Activate: Press and hold the Lock button for | ||
Light Feature - Door Control Panel: Press the | ||
2 seconds. The push bar light will flash as long as | ||
Light button. If the opener light is off, it will turn on. | ||
the Lock feature is on. | ||
If the opener light is on, (even in the | ||
To Turn Off: Press and hold the Lock button for | ||
automatic cycle) it will turn off. | ||
2 seconds again.The push bar light will stop | ||
But if you use the Light button to turn the light(s) on | ||
flashing. Normal operation will resume. The Lock | ||
and then activate the opener, the light(s) will turn off | ||
feature will also turn off whenever the "Smart" | ||
after | ||
button on the opener panel is activated. | ||
The Light button will not control the opener lights | ||
| ||
when the door is in motion. |
|
28