Receiver & Remote Control Programming

NOTICE: To comply with FCC rules, adjustment or modification of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the transmitter battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Your garage door opener receiver and remote control transmitter have been set at the factory to a matching code. The door will activate when the remote control push button is pressed.

Your "Smart" garage door opener will operate with:

•up to four "Smart" remote control transmitters (with green indicator lights),

•a Keyless Entry System, and

W ARN ING

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the door control(s) or remote control transmitter(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

• code switch remote controls with red indicator lights.

Below are instructions for programming your opener to match any additional remotes you may purchase. See available accessories on page 34.

To add a single function remote control:

1. Press and

hold

the remote push button, see Figure 1.

2.Then press and release the "Smart" (learn) button on the right side panel of the opener, Figure 2. The opener

lights will

flash once.

3. Release the remote push button.

Now the opener will operate when the remote control push button is pressed.

If you release the remote control push button before the opener lights flash, the opener will not accept the code.

To change the selected push button on the same remote:

If you decide to use a different remote control button than originally programmed into the opener, you need to erase all the learned codes and reprogram each remote used to operate the garage door opener.

Figure 1

"Smart"Single Function Remote Control

Green Battery

Indicator Light

Push Button

Figure 2

Garage Door Opener(With "Smart" Button)

+

1

 

2

 

3

8

1

8

1

7

3

7

3

5

 

5

+

Kg

 

Kg

"Smart" (learn)

Indicator

Button

Light

To erase all remote control codes:

 

To Add the Keyless Entry

 

We recommend that you program your code before you

• Press and hold the "Smart" button on the opener panel

 

All

install the Keyless Entry. You will not need assistance,

until the indicator light turns off (about 6 seconds).

and you can test the reception at the mounting location

the codes the opener has learned will be erased.

 

 

before installation.

• To reprogram, repeat Steps 1 - 3 for each remote

 

 

1. Choose a 4-digit code using numbers from 0 to 9. You

control in use.

 

 

can use a number more than once (for example, 4, 0,

 

 

 

 

4, 1). Press the selected code digits on the keypad.

Code programming instructions are also located on the opener panel.

2. Press and hold the Enter button while you press the “SRT” (learn) button on the opener panel. The indicator light will blink and the door will begin to move.

3.Release the Enter button. Now the opener has learned the selected keypad code.

To ensure that your portable remote control codes were not disturbed while you were programming the Keyless Entry, test your remotes and reprogram them if necessary.

To change the code at any time, repeat steps 1-3.

29