ADJUSTMENT 1

Program the travel limits

Travel limits regulate the points at which the door will stop when moving up or down. Follow the steps below to set the desired up limit. The down limit will be set automatically during step 5. During this step, use the remote control shipped with your opener. Any other remote will not work until its code is programmed into your opener’s receiver (see “Programming”).

1.Activate the door using the door control or the remote. The trolley will reconnect and the door will open between 4 and 5 feet.

2.Use the two buttons (1), (2) on the control panel to place the opener into limit setting mode:

Press and hold the “Learn” button (2) while you press the “Limit” button on the left (1), then release both buttons. The indicator light (3) will blink slowly. The opener is now in limit learn mode.

3.Press the left button (1) until the door travels up to the desired limit. If the door goes above the desired up limit, press the right button (2) to lower it. Check to be sure the door is high enough for your vehicle. Adjust if necessary, using both buttons.

4.Place a one-inch board (or a 2x4 laid flat) on the floor, centered under the garage door.

5.Press the remote (4) or door control push button. The door will travel down, touch the board, then reverse and stop in the up limit position. The indicator light will stop blinking and turn off. The opener has learned the up and down limits. Remove the wood board.

During step 5, if the door reverses before touching the board, increase the down force (See “Force Adjustment”), then repeat steps 1-5 above.

If the door stops before reaching the up limit, increase the up force by small adjustments until it reaches the up limit. (See “Force Adjustment”). Repeat step 5.

WARNING

Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door.

•Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.

•If one control (force or travel limits) is adjusted, the other control may also need adjustment.

•After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with one-inch high object (or 2x4 laid flat) on floor.

CAUTION

To prevent damage to vehicles, be sure fully open door provides adequate clearance.

Force

Adjustment

Antenna

 

Limit Button (1)

Indicator Light (3)

 

 

 

Learn Button (2)

 

 

(Left)

(Right)

(4)

LOCK

24