Using the Wall-Mounted Door Control
THE MULTI-FUNCTION DOOR CONTROL
B)To operate one door using all three buttons on the
You may program the remote to |
| |
open the door with the large | Open | |
button, close it with the middle | ||
|
Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.
Light feature
LOCK
Push Bar
Light Button
| Close |
button, and stop the door’s | Stop |
| |
movement with the third button. |
|
NOTE: If remote is already programmed, you must first erase all codes. See Programming.
1. With the door closed, press and hold the large |
remote push button. |
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
Lock feature
Designed to prevent operation of the door from hand- held remote controls. However, the door will open and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.The push bar light will stop flashing. The Lock feature will also turn off whenever the “Smart” (learn) button on the motor unit panel is activated.
Additional features when used with the 3-Channel hand-held remote
A) To control the opener lights:
2. Press and hold the Lock button on the door control |
for a minimum of one second before proceeding to |
next step. |
3. Press and hold the door control push bar. |
4. After the opener lights flash, release all buttons. |
To Open the Door Manually
WARNING
•To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
–If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
–NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
In addition to operating the door, you may program the remote to operate the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the Multi- Function door control.
3.While holding the Light button,
press and hold the Lock button
The door should be fully closed if possible. Pull down on the emergency release handle and lift the door manually. To reconnect the door to the opener, press the door control push bar.
Emergency
Release
Handle
(Pull Down)
Trolley
Release
Arm
NOTICE
on the door control.
4.After the opener lights flash, release all buttons.
The lockout feature prevents the trolley from reconnecting automatically, Pull the emergency release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lockout feature, pull the handle straight down. The trolley will reconnect on the next UP or DOWN operation.
MANUAL DISCONNECT
POSITION
Trolley
Release
Arm
Emergency |
|
Release Handle |
|
(Pull Down & Back |
|
Towards Opener) | TICE |
| NO |
LOCKOUT POSITION
28