PROGRAMMING

NOTICE: If this Security✚® garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚® remote controls.

To Add or Reprogram a Hand-held Remote Control

USING THE ìLEARNî BUTTON

USING THE MOTION DETECTING DOOR CONTROL

LOCK

LIGHT

LOCK

LIGHT

1.

Press and release the ìlearnî

 

button on the motor unit. The

 

learn indicator light will glow

 

steadily for 30 seconds.

2.

Within 30 seconds, press and

 

hold the button on the hand-held

 

remote* that you wish to operate

 

your garage door.

3.

Release the button when the

 

motor unit lights blink. It has

1.Press and hold the button on the hand-held remote* that you wish to operate your garage door.

2.While holding the remote button, press and hold the LIGHT button on the Motion Detecting Door Control.

3.Continue holding both buttons while you press the push bar on the Motion Detecting Door Control (all three buttons are held).

LOCK LIGHT

LOCK LIGHT

learned the code. If light bulbs are

not installed, two clicks will be

heard.

4.Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To Erase All Codes From Motor

Unit Memory

To deactivate any unwanted remote, first erase all codes:

Press and hold the ìlearnî button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

*3-Button Remotes

If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any Security✚Æ

3-Button remote or compact remote can be programmed to operate

other Security✚Æ

garage door openers.

27