INSTALLATION STEP 1
Determine the Header Bracket |
| Unfinished |
| OPTIONAL |
| Ceiling |
| ||
|
| CEILING | ||
|
|
|
| |
Location |
|
|
| MOUNT |
WARNING |
|
|
| FOR |
|
|
| HEADER | |
Header Wall |
| 2x4 | BRACKET | |
|
|
| ||
|
|
|
| |
To prevent possible SERIOUS INJURY or DEATH: |
| Vertical Centerline |
|
|
• Header bracket MUST be RIGIDLY fastened to |
|
|
| |
| of Garage Door |
|
| |
structural support on header wall or ceiling, otherwise |
|
| 2x4 | Structural |
garage door might not reverse when required. DO NOT |
|
|
| |
|
|
| Supports | |
install header bracket over drywall. |
|
|
|
|
• Concrete anchors MUST be used if mounting header bracket or 2x4 into masonry.
• NEVER try to loosen, move or adjust garage door, springs, cables, pulleys, brackets, or their hardware, all of which are under EXTREME tension.
• ALWAYS call a trained door systems technician if | Level |
garage door binds, sticks, or is out of balance. An | (optional) |
unbalanced garage door might not reverse when |
|
required. |
|
SECTIONAL DOOR ONLY
1.Close the door and mark the inside vertical centerline of the garage door.
2.Extend the line onto the header wall above the door.
You can fasten the header bracket within 4 feet (1.22 m) of the left or right of the door center only if a torsion spring or center bearing plate is in the way; or you can attach it to the ceiling (see page 9) when clearance is minimal. (It may be mounted on the wall upside down if necessary, to gain approximately 1/2" (1 cm).)
If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown here and on page 9.
3.Open your door to the highest point of travel as shown. Draw an intersecting horizontal line on the header wall 2" (5 cm) above the high point. This height will provide travel clearance for the top edge of the door.
Header Wall
2" (5 cm) Track
Highest Point
of Travel
Door
Sectional door with curved track
8