![](/images/backgrounds/52272/52272-3615x1.png)
INSTALLATION STEP 6
Hang the Opener
Three representative installations are shown. Yours may be different. Hanging brackets should be angled (Figure 1) to provide rigid support. On finished ceilings (Figure 2 and Figure 3), attach a sturdy metal bracket to structural supports before installing the opener. This bracket and fastening hardware are not provided.
1. Measure the distance from each side of the motor unit |
to the structural support. |
2. Cut both pieces of the hanging bracket to required |
lengths. |
3. Drill 3/16" pilot holes in the structural supports. |
4. Attach one end of each bracket to a support with |
5. Fasten the opener to the hanging brackets with |
6. Check to make sure the rail is centered over the door |
(or in line with the header bracket if the bracket is not |
centered above the door). |
WARNING
To avoid possible SERIOUS INJURY from a falling garage door opener, fasten it SECURELY to structural supports of the garage. Concrete anchors MUST be used if installing any brackets into masonry.
Figure 1
Structural
Supports
Measure | Lag Screws | |
Distance | ||
|
Bolt
Lock Washer 5/16"
Nut
7. Remove the 2x4. Operate the door manually. If the |
door hits the rail, raise the header bracket. |
Figure 2
Bracket
Hidden Support
NOTE: DO NOT connect power to opener at this time.
HARDWARE SHOWN ACTUAL SIZE
Lag Screw
Hex Bolt |
|
|
Nut | Lock Washer 5/16" |
(Not Provided)
FINISHED CEILING
Lag Screws
(Not Provided)
Bolt
Lock Washer 5/16"
Nut
Bolt
Lock Washer 5/16"
Nut
Figure 3
Lag Screws
| FINISHED CEILING |
| (Not Provided) |
| Bolt |
| Lock Washer 5/16" |
Bolt | Nut |
| |
Lock Washer 5/16" |
|
Nut |
|
15