LOCKOUT POSITION (MANUAL DISCONNECT)

Using the Wall-Mounted Door Control

Press the push button to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it’s opening.

Push Button

To Open the Door Manually

WARNING

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

• If possible, use emergency release handle to disengage

THE MULTI-FUNCTION DOOR

CONTROL Push

Button

Press the push bar to open or close the

 

 

door. Press again to reverse the door

 

Lock

during the closing cycle or to stop the

 

Button

LOCK

Light

door while it’s opening.

LIGHT

 

Button

Light feature

trolley ONLY when garage door is CLOSED. Weak or broken

springs or unbalanced door could result in an open door

falling rapidly and/or unexpectedly.

• NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

• NEVER use handle to pull door open or closed. If rope knot

becomes untied, you could fall.

Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outside Keylock

DISCONNECT TROLLEY:

The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually.

The lockout feature prevents

N

OTICE

the trolley from reconnecting

 

 

automatically, and the door

 

 

can be raised and lowered

 

 

manually as often as necessary.

 

 

TO RE-CONNECT THE TROLLEY:

Trolley

Trolley Release

Arm (in Manual

Disconnect Position)

and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for

2 seconds.The push bar light will stop flashing. The Lock feature will also turn off whenever the “Learn” button on the motor unit panel is activated.

Additional features when used with the 3-Button hand-held remote

To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a small remote button that you want to control the light.

2.Press and hold the Light button on the Multi-Function door control.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

Pull the emergency release handle toward the opener at a 45° angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote.

Trolley

 

Trolley

 

Release

 

Arm

Emergency

NOTICE

Release Handle

 

(Pull at 45° angle)

 

TO RECONNECT

 

27