Preparing your garage door

Before you begin:

•Disable locks.

•Remove any ropes connected to garage door.

•Complete the following test to make sure your garage door is balanced and is not sticking or binding:

1.Lift the door about halfway as shown. Release the door. If balanced, it should stay in place, supported entirely by its springs.

2.Raise and lower the door to see if there is any binding or sticking.

If your door binds, sticks, or is out of balance, call a trained door systems technician.

To prevent possible SERIOUS INJURY or DEATH:

•ALWAYS call a trained door systems technician if garage door binds, sticks or is out of balance. An unbalanced garage door may not reverse when required.

•NEVER try to loosen, move or adjust garage door, door springs, cables, pulleys, brackets or their hardware, ALL of which are under EXTREME tension.

•Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid entanglement.

To prevent damage to garage door and opener:

•ALWAYS disable locks BEFORE installing and operating the opener.

•ONLY operate garage door opener at 120V, 60 Hz to avoid malfunction and damage.

Sectional Door
One-Piece Door

Tools needed

During assembly, installation and adjustment of the opener, instructions will call for hand tools as illustrated below.

Pencil

Carpenter’s Level (Optional)

1

2

Tape Measure

Hack Saw

Wire Cutters

 

Drill

3/16", 5/16" and

 

Claw Hammer

 

 

5/32" Drill Bits

 

Pliers

 

 

 

 

Stepladder

1/2" and 7/16" Sockets

Screwdriver

 

and Wrench

 

Adjustable End Wrench

 

 

 

3