Chamberlain 3280M, 3280M-267 Determine the Header Bracket Location, NOTE:, INSTALLATION STEP, You can fasten the header bracket within 4 feet (1.22

INSTALLATION STEP 1

Determine the Header Bracket Location

To prevent possible SERIOUS INJURY or DEATH:

•Header bracket MUST be RIGIDLY fastened to structural support on header wall or ceiling, otherwise garage door might not reverse when required. DO NOT install header bracket over drywall.

•Concrete anchors MUST be used if mounting header bracket or 2x4 into masonry.

•NEVER try to loosen, move or adjust garage door, springs, cables, pulleys, brackets, or their hardware, all of which are under EXTREME tension.

•ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of balance. An unbalanced garage door might not reverse when required.

Installation procedures vary according to garage door types. Follow the instructions which apply to your door.

1.Close the door and mark the inside vertical centerline of the garage door.

2.Extend the line onto the header wall above the door.

You can fasten the header bracket within 4 feet (1.22

m)of the left or right of the door center only if a torsion spring or center bearing plate is in the way; or you can attach it to the ceiling (see page 9) when clearance is minimal. (It may be mounted on the wall upside down if necessary, to gain approximately 1/2" (1 cm).

If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown here and on page 9.

3.Open your door to the highest point of travel as shown. Draw an intersecting horizontal line on the header wall above the high point:

•2" (5 cm) above the high point for sectional door and one-piece door with track.

•8" (20 cm) above the high point for one-piece door without track.

This height will provide travel clearance for the top edge of the door.

NOTE: If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 9 for ceiling installation.

	Unfinished		OPTIONAL
	Ceiling
			CEILING
			MOUNT
			FOR
			HEADER
			BRACKET
Header Wall		2x4
	Vertical Centerline
	of Garage Door
		2x4	Structural
			Supports

Level (optional)

Header Wall
2" (5 cm) Track	Header Wall Track
	2" (5 cm)
Highest Point
of Travel	Highest Point
	of Travel
	Door
Door

Sectional door with curved track One-piece door with horizontal track

		Header Wall
	Header Wall	8" (20 cm)
	8" (20 cm)
	Highest	Highest
Door		Point
	Point	of Travel
	of Travel	Door
Jamb
Hardware
		Pivot
One-piece door without track:		One-piece door without track:
jamb hardware		pivot hardware

8