INSTALLATION STEP 7

Install the Battery Backup (Optional)

•Make sure motor unit is unplugged.

•Using a Phillips head screwdriver, remove the battery cover on the motor unit.

•Partially insert battery into motor unit with terminals facing out.

•Connect red (+) and black (-) wires from motor unit to corresponding terminals on battery.

•Replace battery cover.

INSTALLATION STEP 8

Battery

CAUTION

Battery Cover

Install the Lights

•Press the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens.

•Install up to a 100 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

•Reverse the procedure to close the lens.

•If the bulbs burn out prematurely due to vibration, replace with a Garage Door Opener bulb.

NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket.

To prevent possible OVERHEATING of the end panel or light socket:

•DO NOT use short neck or specialty light bulbs.

•DO NOT use halogen bulbs. Use ONLY incandescent.

100 Watt (Max)

Standard Light Bulb

Release Tab

Lens

100 Watt (Max)Hinge

Standard Light Bulb

14