Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply to your installation. Additional materials may be required. You may find it helpful to refer back to this page and the accompanying illustrations as you proceed with the installation of your opener.
SECTIONAL DOOR INSTALLATION |
|
| FINISHED CEILING |
|
|
| Support bracket & |
|
|
| fastening hardware |
Horizontal and vertical reinforcement |
|
| is required. |
|
| See page 12. | |
is needed for lightweight garage doors |
|
| |
|
|
| |
(fiberglass, steel, aluminum, door with |
|
|
|
glass panels, etc.). See page 19 for details. |
|
|
|
Header Wall |
|
|
|
|
| Extension | Motor Unit |
|
|
| |
| Torsion | Spring |
|
| OR |
| |
| Spring |
| |
|
|
|
— | Vertical | Access | |
Door | |||
— | |||
Centerline |
| ||
— |
| ||
of Door |
| ||
|
| ||
|
| Wall- | |
— |
| mounted | |
| Door | ||
— |
| ||
| Control | ||
— |
| ||
|
| ||
— — |
|
|
Safety
Gap between floor and bottom Reversing Sensor
of door must not exceed 1/4" (6 mm)
Safety
Reversing Sensor
FINISHED CEILING
Support bracket & fastening hardware is required. See page 12.
Header
Wall
Motor Unit
Wall- mounted
Door
Control Access
Door
Safety
Reversing Sensor
Gap between floor and bottom of
Safety door must not exceed 1/4" (6 mm) Reversing Sensor
ONE-PIECE DOOR WITH TRACK
Access
Door
Safety Reversing Sensor
Gap between floor and bottom of door must not exceed 1/4" (6 mm).
Safety Reversing Sensor
4