Radio Controls
F.C.C. rules prohibit adjustments to or modification of receiver and/or remote control transmitter circuitry except for changing code setting and replacing remote control transmitter battery. NO USER SERVICEABLE PARTS.
Manufactured under 1 or more of the following U.S. patents: RE29,525;4,037.201;
4.750.118; 4.806.930 | Other Patents Pending. |
ACTIVATE THE OPENER ONLY WHEN DOOR IS IN FULL VIEW, FREE OF OBSTRUCTION AND PROPERLY
ADJUSTED. NO ONE SHOULD ENTER OR LEAVE GARAGE WHILE DOOR IS IN MOTION. DO NOT ALLOW CHILDREN TO OPERATE REMOTES OR DOOR CONTROL BUTTONS. DO NOT ALLOW CHILDREN TO PLAY NEAR THE DOOR.
Your garage door opener receiver and remote control transmitter have been factory set to a matching
code. Models having
MATCH/CHANGE THE CODE IN REMOTE CONTROL(S)
Slide battery compartment cover back to access code switches in your remote control and any new remote. Place remotes side by side as shown. Use a pen or screwdriver to slide the switches to
Multi- FunctionRemotes: Set code switches 2 through 9 in ALL remotes to matching positions. Code switch 1 in a multi- function remote is neutral. It can be set to any position.
Single Function Remotes: Set code switched 1 through 9 to matching positions.
Combination of Single and
|
|
When used with
Code Switch #1 in a
MATCH/CHANGE THE CODE IN THE RECEIVER
"SMART"GARAGE DOOR OPENERS
Set all remotes to matching code settings as shown above. Select a push button to operate the door opener.
MULTI-FUNCITON REMOTE CONTROL ONLY:
Select a push button to operate receiver. LARGE button is reccommended for garage door opener.
YOU MAY WANT SOMEONE TO HELP AT THIS POINT!
1.Press and HOLD the selected remote control push button.
2.Then press the receiver ‘Smart’ button on the back panel of the opener. The adjacent indicator light will FLASH and the door will begin to MOVE. Release the remote
control push button.
The opener will now operate when either the door control push button or the transmitter push button is pressed.
NOTE: If the transmitter push button is not held down until the receiver indicator light flashes, the receiver will not learn the code.
To use the
To use the
23