®

Model 963D Security✚® 3-Button Remote Control

with Proximity Lighting Feature

OWNER’S MANUAL

For use with 315MHz Security✚® garage door openers and universal receivers that have a purple “learn” button and 315MHz gate receivers.

NOTE: To activate the remote control functions, pull out the plastic pull tab protruding from the remote control housing.

This remote control is equipped with a proximity lighting feature. When moving a hand within close proximity to the remote control, the LED lights turn on for 3 seconds. Upon successful activation of a remote control button, the LED lights will blink rapidly.

Proximity Disable Feature

The remote control will turn off the proximity lighting feature if the proximity lighting is turned on 10 consecutive times without activation of a button. To re-enable the proximity lighting, simply press a button. This function conserves battery life.

To Add or Reprogram the Remote Control

OR

1. Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.

2. Within 30 seconds, press and hold the button on the hand-held remote.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:

•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote control transmitters.

•Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.

•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.

To Control the Opener Lights

NOTE: Feature only available on openers equipped with a multi-function control panel.

With 315MHz Security✚® remote controls, a remote push button can be programmed to operate the opener lights without opening the door.

1.With the door closed, press and hold the remote button that you want to control the light.

2.Press and hold the Light button on the multi-function control panel.3.Press and hold the Lock button on the multi-function control panel.4.After the opener lights flash, release all buttons.

Test by pressing the remote push button. The opener lights should turn on or off but the door should not move.

Open/Close/Stop Operation

NOTE: Feature only available on openers equipped with a multi-function control panel.

Your 315MHz Security✚® remote control can be programmed to operate one door using all 3 buttons: the button with one light slot will only open the door, the button with two light slots will close the door, and the button with three light slots will stop the door’s movement. You may set up this feature as follows:

3. Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
1.With the door closed, press and hold the button with one light slot.2.Press and hold the Lock button on the multi-function control panel.3.Press and hold the main door control push button.

1 Light Slot

(Open)

2 Light Slots

(Close)

3 Light Slots (Stop)

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

When the opener lights flash, release all buttons. Test by pressing the 1 light slot button (Open) on the remote. The door should open. Press it again while the door is open and nothing should happen. Press the 2 light slot button (Close) while the door is moving and it should close. Press the 3 light slot button (Stop) and the door should stop immediately.