The Remote Control Batteries

To prevent possible SERIOUS INJURY or DEATH:

•NEVER allow small children near batteries.

•If battery is swallowed, immediately notify doctor.

To reduce risk of fire, explosion or chemical burn:

•Replace ONLY with 3V2016 or 3V2450 coin batteries.

•Do NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.

The 3V2016 lithium batteries for the opener and LED lights (marked “LED and Opener Battery”) should last 5 years. The 3V2450 lithium battery for the proximity lighting (marked “Proximity Battery”) should last 1-2 years.

To replace the batteries, remove the two screws and open the remote control housing. Push the battery out of the holder for removal. Insert replacement batteries positive side up (+).

Dispose of old batteries properly.

Replace the batteries with only 3V2016 or 3V2450 coin cell batteries.

CAUTION: Do not bend spring contact. If bent, the proximity sensor will not work.

Proximity

Battery

LED and

 

Opener

Spring

Batteries

Contact

 

Troubleshooting

 

PROBLEM

 

SOLUTION

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Check if proximity lighting is disabled

 

 

 

 

 

by pressing a button.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The Proximity Sensor may be

 

Reduced proximity

 

 

 

 

oversensitized. Sit remote control

 

 

sensing (does not

 

 

 

 

 

 

undisturbed for 60 seconds on a

 

 

activate by touching

 

 

 

 

 

 

non-metallic surface. This allows the

 

 

top of remote control)

 

 

 

 

 

 

sensor to recalibrate itself.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Replace 3V2450 battery with same

 

 

 

 

 

type 3V2450 coin cell.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Replace two 3V2016 batteries with

 

Dim LED lights

 

 

 

 

 

 

same type 3V2016 coin cells.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

No rapid LED blinking

 

Replace two 3V2016 batteries with

 

after pressing a button

 

same type 3V2016 coin cells.

 

 

 

 

 

 

 

 

Replacement Parts

PART NO.
DESCRIPTION
QTY

10A19

3V2016

Lithium Battery: LED and Opener

2

10A33

3V2450

Lithium Battery: Proximity Switch

1

29C151

Visor Clip

1

FOR SERVICE, DIAL OUR TOLL FREE NUMBER: 1-800-528-9131

NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

 

©2007, Chamberlain Group Inc.

114A3566

All Rights Reserved