MOUNTING AND WIRING THE SAFETY SENSORS

•Slide a 1/4"-20x1/2" carriage bolt head into the slot on each sensor. Use wing nuts to fasten sensors to brackets, with lenses pointing toward each other across the door. Be sure the lens is not obstructed by a bracket extension. See Figure 4.

•Finger tighten the wing nuts.

•Run the wires from both sensors to the opener. Use insulated staples to secure wire to wall and ceiling.

•Strip 1/4" of insulation from each set of wires. Separate white and white/black wires sufficiently to connect to the opener terminal screws: white to 2 and white/black to 3. See Figure 5.

ALIGNING THE SAFETY SENSORS

•Plug in the opener. The indicator lights in both the sending and receiving eyes will glow steadily if wiring connections and alignment are correct.

The sending eye orange indicator light will glow regardless of alignment or obstruction. If the green indicator light in the receiving eye is off, dim, or flickering (and the invisible light beam path is not obstructed), alignment is required.

•Loosen the sending eye wing nut and readjust, aiming directly at the receiving eye. Lock in place.

•Loosen the receiving eye wing nut and adjust sensor until it receives the sender’s beam. When the green indicator light glows steadily, tighten the wing nut.

Figure 4

Wing nut

Carriage bolt

1/4"-20x1/2"

Lens

TROUBLESHOOTING THE SAFETY SENSORS

1.If the sending eye indicator light does not glow steadily after installation, check for:

•Electric power to the opener.

•A short in the white or white/black wires. These can occur at staples, or at screw terminal connections.

•Incorrect wiring between sensors and opener.

•A broken wire.

2.If the sending eye indicator light glows steadily but the receiving eye indicator light doesn't:

•Check alignment.

•Check for an open wire to the receiving eye.

3.If the receiving eye indicator light is dim, realign either sensor.

NOTE: When the invisible beam path is obstructed or misaligned while the door is closing, the door will reverse. If the door is already open, it will not close. The opener lights will blink 10 times. (If bulbs are not installed, 10 clicks can be heard.) See page 17.

Connect Wire to

Opener Terminal Screws

Figure 5

 

Finished

Bell Wire

Ceiling

 

Door Control

 

Sensor

Bell Wire

 

Connections

Connections

 

 

 

 

 

(dotted line)

 

 

 

1

2

3

OPENER TERMINAL SCREWS

Sensor

Sensor

Invisible Light Beam

Protection Area

19