INSTALLATION STEP 7
Install the Light and Lens
INSTALL THE LIGHTS
•Install a 75 watt maximum light bulb in the socket. The light will turn ON and remain lit for approximately
•Use standard neck Garage Door Opener bulbs for replacement.
INSTALL THE LENS
The Force Adjustment control and “learn” button are located on the back panel. For convenience, you may wish to install the lens after installation and adjustment procedures are completed.
•Slide lens into guides. Snap bottom tabs into lens slots.
•Reverse the procedure to remove the lens.
Lens
Guide
Lens
Tab
Lens
Slot
75 Watt (Maximum) Light Bulb
INSTALLATION STEP 8
Attach the Emergency Release Rope and Handle
•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot at least 1" from the end of the rope to prevent slipping.
•Thread the other end of the rope through the hole in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
WARNING
•To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
–If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
–NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
Overhand
Knot
Trolley |
| Trolley |
| Rope | Release Arm |
|
|
Emergency
Release Handle
19