PROGRAMMING

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚ remote controls.

To Add an Additional Hand-held Remote Control

USING THE “LEARN” BUTTON

USING THE MULTI-FUNCTION DOOR CONTROL

1.Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.

2.Within 30 seconds, press and hold the button on the hand-held remote* that you wish to operate your garage door.

3.Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

123

12

12

1. Press and hold the button on the hand-held remote* that you wish to operate your garage door.

KG

2.While holding the remote button, press and hold the LIGHT button

on the Multi-Function Door Control.

3.Continue holding both buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held).

4. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

LOCK

LIGHT

LOCK

LIGHT

LOCK

LIGHT

To Erase All Codes From Motor

Unit Memory

To deactivate any unwanted remote,

1

2

 

 

first erase all codes:

 

 

Press and the hold “learn” button on

 

 

motor unit until the learn indicator

 

KG

light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

*Multi-Function Remotes

If supplied with your

garage door opener, the large button is factory programmed to

operate it. Additional buttons on any Security✚ multi-

function remote or mini-remote can be programmed to operate other Security✚ garage door openers.

35