TABLE OF CONTENTS
Preparing Your Garage Door . . . . . . . . . . . . . . . . . . . . . 2
Completed Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Tools Needed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Opener Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Assembly Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installation Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
Installation safety instructions. . . . . . . . . . . . . . . . . . . . . . 9 Install the header bracket . . . . . . . . . . . . . . . . . . . . . . . . 10 Mount the header bracket . . . . . . . . . . . . . . . . . . . . . . . . 11 Position and hang motor unit . . . . . . . . . . . . . . . . . . . . . 12 Fasten the door bracket . . . . . . . . . . . . . . . . . . . . . . . . . 13 Attach door to trolley. . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Installing the door control . . . . . . . . . . . . . . . . . . . . . . . . 15 Installing the light bulb(s) . . . . . . . . . . . . . . . . . . . . . . . . 16 Electrical requirements . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Install the Protector System® . . . . . . . . . . . . . . . . . . .
Adjustment
Adjust the UP and DOWN travel limits . . . . . . . . . . . . . . 20 Adjust the forces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Test the safety reversal system . . . . . . . . . . . . . . . . . . . 22 Test the Protector System® . . . . . . . . . . . . . . . . . . . . . . . 22
PREPARING YOUR GARAGE DOOR
Before you begin:
•Disable locks (contact your door manufacturer for information on disabling your door locks.)
•Remove any ropes connected to garage door.
•Complete the following test to make sure your garage door is balanced and is not sticking or binding:
1.Lift the door about halfway as shown. Release the door. If balanced, it should stay in place, supported entirely by its springs.
2.Raise and lower the door to see if there is any binding or sticking.
If your door binds, sticks, or is out of balance, call a trained door systems technician.
If you have a
Operation
Important Safety Information . . . . . . . . . . . . . . . . . . . . . 23 Using your garage door opener . . . . . . . . . . . . . . . . . . . 23 Using the
Having a Problem? . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
Diagnostic Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Programming
To add or reprogram an additional
change a keyless entry PIN . . . . . . . . . . . . . . . . . . . . . . 28 To change an existing, known PIN . . . . . . . . . . . . . . . . . 28 To set a temporary PIN. . . . . . . . . . . . . . . . . . . . . . . . . . 29 To erase all codes from motor unit memory . . . . . . . . . . 29 The remote control battery . . . . . . . . . . . . . . . . . . . . . . . 29
Repair Parts
Rail assembly parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Installation parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Motor unit assembly parts. . . . . . . . . . . . . . . . . . . . . . . . 31
Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warranties . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Repair Parts and Service . . . . . . . . . . . . . . . . . . . . . . . 36
WARNING
To prevent possible SERIOUS INJURY or DEATH:
•ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of balance. An unbalanced garage door may not reverse when required.
•NEVER try to loosen, move or adjust garage door, door springs, cables, pulleys, brackets or their hardware, ALL of which are under EXTREME tension.
•Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid entanglement.
CAUTION
To prevent damage to garage door and opener:
•ALWAYS disable locks BEFORE installing and operating the opener.
•ONLY operate garage door opener at 120V, 60 Hz to avoid malfunction and damage.
Sectional Door | |
2 | See addendum |
|