WIRE SAFETY REVERSING SENSOR

Option A: Installation Without Pre-Wiring

3.1a Run Safety Reversing Sensor Wire to Motor Unit and Secure with Insulated Staples

PRE-WIRED INSTALLATIONS: If your garage already has wires installed for the safety reversing sensors, refer to the instructions on the following page.

C1

Insulated Staple

3.3a Connect Safety Reversing Sensors to Motor Unit

To insert or remove the wires from the terminal, push in the tab with a screwdriver tip.

3.2a Separate the Black/White and the White Wires

Strip 7/16" (11 mm)

7/16" (11 mm)

Strip 7/16 inch (11 mm) of insulation from each set of wires. Separate the wires. Twist the white wires together. Twist the white/black wires together.

Insert the white wires into the white terminal on the garage door opener. Insert the white/black wires into the grey terminal on the garage door opener.

ALL HARDWARE SHOWN ACTUAL SIZE

C1 Insulated Staples

19