Chamberlain PD752DS, PD752KDS, PD752KLDS Wood Doors:, Metal Doors:, ONE-PIECEDOORS

ONE-PIECE DOORS

Please read and comply with the warnings and reinforcement instructions on the previous page. They apply to one-piece doors also.

•Center the door bracket on the top of the door, in line with the header bracket as shown. Mark either the left and right, or the top and bottom holes.

•Metal Doors: Drill 3/16" pilot holes and fasten the bracket with the 1/4"-14x5/8” self-threading screws provided.

•Wood Doors: Drill 5/16" holes and use 5/16"x2" carriage bolts, lock washers and nuts (not provided) or 5/16"x1-1/2" lag screws (not provided) depending on your installation needs.

NOTE: The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.)

HARDWARE SHOWN

ACTUAL SIZE

Self-Threading Screw 1/4"-14x5/8"

Header Wall

	- Finished Ceiling -		Self-Threading
2x4	Header	Door	Screw 1/4"-14x5/8"
Support	Bracket	Bracket	Top of Door
			(Inside Garage)
			Top Edge
			of Door
			Optional
Door			Placement
Bracket			METAL DOOR
Optional	HORIZONTAL	Nut	Lock
Placement
	AND VERTICAL
of Door		5/16"-18	Washer 5/16"
	REINFORCEMENT
Bracket
	IS NEEDED FOR	Door
			Top of Door
	LIGHTWEIGHT
		Bracket
Vertical			(Inside Garage)
	GARAGE DOORS
Centerline
	(FIBERGLASS,
of Garage
	ALUMINUM,		Top Edge
Door
	STEEL, DOORS
			of Door
	WITH GLASS
			Optional
	PANEL, ETC).
	(NOT PROVIDED)		Placement
			Carriage Bolt
			5/16"x2"
			(Not Provided)
	For a door with no exposed framing, or for the		WOOD DOOR
	optional installation, use lag screws 5/16"x1-1/2"
	(Not Provided) to fasten door bracket.

24