•Slide a
•Finger tighten the wing nuts.
Option A - Installation Without•Run the bell wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with the staples (Figure 6).
Option B -If your garage already has wires installed for the safety reversing sensors, follow the instructions below:
•Cut the end of the safety reversing sensor wire, making sure there is enough wire to reach the
•Separate the safety reversing sensor wires and strip 7/16" (11 mm) of insulation from each end. Choose two of the
•Connect the
Figure 5
Wing Nut
Carriage Bolt
Lens
Figure 6
Figure 7
Figure 8
Safety Reversing
Sensor Wires7/16"
(11 mm)
|
| 7/16" |
| (11 mm) | |
|
| |
| Wires |
|
Figure 9 | Not Provided |
|
|
| |
Safety Reversing |
| |
Sensor Wires | White | Wires |
|
| |
| White/Black |
|
21