Switch Settings

Antenna

PIR Sensor

Switch #1

Test Switch #2

Button

Programming PIR Motion Sensor to Base Station

Step 5

Switch #1:.

 

 

 

 

 

 

OFF

6 m Detection Range

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ON

12 m Detection Range

 

 

 

 

 

 

 

 

(Default)

 

 

 

 

 

 

Switch #2:

 

 

 

 

 

OFF

 

 

 

 

 

 

 

 

 

 

OFF

Low Sensitivity

 

 

 

 

 

 

 

 

1

 

2

 

ON

ON

High Sensitivity

 

 

 

 

 

 

 

(Default)

 

 

 

 

 

 

 

 

 

 

 

 

 

Step 3

Plug in Base Station. Adhere rubber pads to bottom. A

9-Volt battery (not provided) is optional in case of power failures.

OPTIONAL

A

B

Insert battery pack facing away from circuit board and attach cover.

NOTE: Ensure the batteries do not touch the circuit board and the antenna and battery wires are not pinched.

Step 4

Step 6

 

 

 

A Ensure Base

 

A

Station and PIR

 

 

 

 

 

 

Motion Sensor are

 

 

 

in close proximity

 

 

 

to each other.

 

 

 

Press and release

 

 

 

learn button on

 

 

 

Base Station.

 

 

 

Buzzer will sound.

 

 

 

B

 

Test PIR Motion Sensor by waving hand in front of sensor. Test light should flash. Secure cover with the smallest screws.

B Within 5 seconds, wave hand in front of PIR Motion Sensor. Test light will illuminate and Base Station will buzz.

2