Using the Wall-Mounted Door Control

 

THE MULTI-FUNCTION DOOR CONTROL

 

Press the lighted push button to

Push

open or close the door. Press again

Button

to reverse the door during the

 

closing cycle or to stop the door

Lock

while it's opening.

Button

Light feature

Light

 

Button

Press the Light button to turn the

opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2 or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for

2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.

Additional feature when used with the 3-Button hand-held remote

To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a small remote button that you want to control the

light.

2. Press and hold the Light button on the door control.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

•If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/ or unexpectedly.

•NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.

•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.

DISCONNECT THE TROLLEY:

 

Trolley

 

 

 

 

The door should be fully closed

 

 

if possible. Pull down on the

 

 

 

emergency release handle (so

 

 

 

that the trolley release arm

 

Trolley

 

snaps into a vertical position)

 

 

 

Release Arm

 

and lift the door manually.

 

 

 

(In Manual

 

The lockout feature prevents

 

Disconnect

 

the trolley from reconnecting

 

Position)

 

automatically, and the door can

 

 

be raised and lowered manually

Lockout position

as often as necessary.

 

 

(Manual disconnect)

 

 

TO RE-CONNECT THE TROLLEY:

Trolley

 

Pull the emergency release

 

 

 

 

 

handle toward the opener at

 

 

 

an angle so that the trolley

 

 

 

release arm is horizontal.

 

 

Trolley

The trolley will reconnect

 

 

Release

on the next UP or DOWN

Emergency

Arm

operation, either manually or

Release Handle

 

by using the door control or

(Down and Back)

 

remote.

To reconnect

31