Acu-Rite 13230 warranty Introduction, Battery Choice & Temperature Range, Overview, Setup

Overview

Introduction

Thank You for purchasing this Acurite® product. Please read through this manual in itʼs entirety to fully enjoy the benefits and features of this product. Please keep this manual for future reference.

NOTE: A protective film is applied to the LCD at the factory that must be removed prior to using this product. Locate the clear tab and simply peel to remove.

	Outdoor
Weather	Temperature
Forecast	Outdoor
	Humidity
	Month,Date
	Intelli-Time®
Pressure	Clock
Graph	Moon Phase

SETUP

Battery Choice & Temperature Range

Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause alkaline batteries to function improperly. This will cause the outdoor wireless sensor to stop transmitting temperature readings. Use lithium batteries in these low temperature conditions to ensure continued operation for wireless sensors placed outdoors. NOTE: Rechargeable batteries are not recommended due to higher operating voltages.

1

SETUP

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove battteries from equipment which is not to be used for an extended perid of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in ￿re, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

A/B/C Wireless Selection

To allow for more than one weather station and wireless sensor network to be used in close proximity, the display unit and the wireless sensor have a small switch labeled “A B C” within the battery compartments. This switch selects one of 3 wireless modes to use, and both switchs MUST be set in matching positions (either A, B, or C) fore wireless communication to take place successfully.

Installing Batteries - Wireless Sensor

Remove the battery compartment cover. Install 2 fresh “AA” batteries as shown here. BATTERIES MUST BE INSTALLED FOR

THE SENSOR TO OPERATE

Installing Batteries - Display Unit

Remove the battery compartment cover.

Install 3 fresh “AA” batteries into the battery compartment.

Replace the battery compartment cover.

2