Model IC812
Mounting screws (4)
Installation:
Use the provided template to mark and cut a
We recommend wiring with AWG 16 or larger, stranded wire.
For proper phasing, both speakers must be wired alike. Connect red wires to red terminals on the speakers and to red or plus terminals on the amplifier.
Install IC812 in the hole. Tighten the mounting screws. The mounting “dogs ears” will rotate outward and grip the drywall. DO NOT OVER TIGHTEN the screws. A battery operated drill on a “low clutch” setting is recommended.
Aim tweeter
To control the volume of the speaker locally, use an impedance matching volume control, such as the Channel Vision VC300.
Features:
8” High performance
Gold speaker terminals
Proprietary pivoting “Pole Piece” technology with 1” voice coil.
Polypropylene woofer with butyl rubber surround and an 18 ounce magnet
Small perforated designer grille
Recommended power: 20W to 180W (peak)
Specifications:
Frequency range: | 35Hz - 20kHz ± 6dB |
Crossover: | 12dB/octive (low pass) |
| 12dB/octive (high pass) |
Sensitivity: | 91dB (1W/1m) |
Power Handling: | 180 Watts peak |
Drivers: | 1- 1” Soft dome tweeter |
| 1- 8” polypropylene woofer |
Magnet: | |
Impedance: | 8 ohms |
Finish: | ABS plastic |
Dimensions: | |
| (from surface of wall board) |
| hole size: |
| Specifications subject to change without notice. |
2 | 3 |