Char-Broil 11601578, 11601559 Grill Final Assembly, Controller cord Behind the towel bar as shown

8 ASSEMBLY GUIDE GRILL FINAL Assembly

		Part	Qty.
C4	–	Controller	1	Fasteners
C5	–	Lid Handle	1

10-24x3/8"

screw	Fiber Washer
(qty 2)	(qty 2)

NOTE: Be sure to press the controller into the receptacle as far as it will go. Route the

controller cord BEHIND the towel bar as shown.

Step 1 - Install the Controller (C4) into the receptacle. Be sure to route the controller cord behind the towel bar when installing the controller. The control knob should be facing up as you engage the tip of the controller into the receptacle. Push the controller in all the way until you hear a click, this will ensure your controller is installed properly.

Towel Bar

C4

Receptacle

Controller

Controller Tip

Step 2 - Install the Lid Handle with 2 10-24x3/8" screws and 2 fiber washers as shown.

	C5
	10-24x3/8"
Fiber	Screws
Washer	(2 each)
(2 each)

Ground Fault Interrupter

?Since 1971 the National Electric Code (NEC) has required Ground Fault Interrupter devices on all outdoor circuits.

?If your residence was built before 1971, check with a qualified electrician to determine if a Ground Fault Interrupter protector exists.

?Do not use this appliance if the circuit does not have GFI protection.

?Do not plug this appliance into an indoor circuit.

Congratulations! You have successfully completed the assembly of your grill.

Visit www.sizzleonthegrill.com/user-forumsto chat with Patio Bistro® owners just like you!