Upper back panel | Char-Broil 463232011 manual

5

On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower holes, using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer on each side.

Do not fully tighten screws until side shelf installation is complete in later steps.

Upper back panel

1/4-20x1½”	7mm lock	7mm flat
screw	washer	washer

15

Image 15

Char-Broil 463232011 manual Upper back panel

Contents

Date Purchased Estimated assembly time 30 minutes This Grill is for Outdoor USE only Table of Contents California Proposition Installation Safety Precautions USE and Care LP Liquefied Petroleum GasLP Cylinder Filling For your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Leak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lighting Burner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match Lighting Turn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valve Items Manufacturer will not PAY for Limited Warranty Key Qty Description Parts List Parts Diagram Front Assembly Grill head Regulator hose Upper back panel Back of main control panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Rear Wire Clarity of illustrationAssembled warming rack Grease tray Cylinder screw at rear of cart Emergencies Possible Cause Prevention/Solution Troubleshooting AUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Page Page Warranty Registration Department Box Columbus, GA