Char-Broil 463247412 manual Rear, Front, Wire, self-tapping screw

12

Inside of cart, insert rear shield tab into left slot on upper of lower back panel. Insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach front shield tabs under front brace and attach right and left rails under front brace with three #8x3/8” self-tapping screws, shown B.

	Tank heat shield
Rear	*This side UP

Front

Tank heat shield

Note: some parts omitted for clarity of illustration

B

Front Brace

A

Cart lower back panel

#8x3/8”

self-tapping screw

Right rail

Left rail

Left rail

Right rail

Tank heat shield

Grease tray opening

13

Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with the nut and cap, shown A.

Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition Module.Total (4) connections.

Connect the two wires(A and B) from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections.

NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as A,B.

A

Electronic
ignition module	Right side panel

Nut Cap

1

2 A

3

4

B

Wire

19