Manuals / Char-Broil / Outdoor Cooking / Charcoal Grill

Char-Broil 463247412 manual Cylinder valve must face to front of cart once

Models: 463247412

1 28

Download 28 pages 41.97 Kb

Page 22

Cylinder valve must face to front of cart once

18

Unscrew electronic ignition cap on cart right side panel. Insert AA battery into ignitor, negative (—) end first. Replace the cap.

AA Battery

-+

Electronic Ignition Cap

19

LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use & Care section). Once cylinder has been filled and leak checked, place cylinder into hole in bottom shelf. Make sure cylinder valve is facing front of grill. Secure cylinder with cylinder screw under bottom shelf. Insert regulator through large hole in

left side panel. See Use & Care section of this manual to perform the “Burner Flame Check” and for important safety instructions before using.

Cylinder screw at rear of cart

Cylinder screw

Always keep LP cylinders in upright position during use, transport, and storage.

CAUTION

Cylinder valve must face to front of cart once	Regulator
tank is attached. Failure to install cylinder
correctly may allow gas hose to be damaged
in operation, resulting in the risk of fire.

LP Cylinder ( not included)

.

22

Image 22

Char-Broil 463247412 manual Cylinder valve must face to front of cart once, tank is attached. Failure to install cylinder

Contents

If you have questions or need assistance during assembly Char-Broil Commercial T-36Dplease call Assembly instructionsCONSUMER INSTALLER/ASSEMBLERDANGER DANGERWash your hands after handling this product USE AND CARE Failure to use safety cap as directed may result in seriousDANGER LP CylinderFor your safety Connecting Regulator to the LP CylinderLeak test new and exchanged LP cylinders BEFORE connecting to grill useDo not household cleaning agents. Damage to gasLeak Testing Valves, Hose and Regulator DANGERFor Safe Use of Your Grill and to Avoid Serious Injury Ignitor Lighting continued Storing Your Grill Cleaning the Burner AssemblySPIDER ALERT VERY IMPORTANT Burner tubes must reengage valvePERIOD OF COVERAGE LIMITED WARRANTYSCOPE OF COVERAGE TYPE OF FAILURE COVERAGEDescription PARTS LISTDescription NOT PicturedPARTS DIAGRAM 1/4-20x1/2” screws, 7mm lock washers, and ASSEMBLYAttach side panels to bottom shelf using three 7mm flat washers per panelpanels at rear of bottom shelf. Secure lower back panel to side panels using twoPlace lower back panel between side 1/4-20x1/2” screws, 7mm lock washersUpper back panel 7mm flat washer Now you may fully tighten lower screws on upper back panelBack of main control panel Note Use left and right holes on fascia to attach valve bracket Note Use upper and lower holes on fascia to attach bezel1/4-20x1½” Sideburner grateFront brace screwFront WireRear self-tapping screwNote Some parts omitted for clarity of illustration Flame tamersWarming rack Cooking grate Note Some parts omitted for clarity of illustrationGrease tray correctly may allow gas hose to be damaged tank is attached. Failure to install cylinderCylinder valve must face to front of cart once in operation, resulting in the risk of fireGAS ISSUES Prevention/SolutionProblem ELECTRICAL ISSUESAUTO-CLEAN ProblemPrevention/Solution Prevention/SolutionPrevention/Solution Problem IgnitionCheck Procedure Possible CausePage Warranty Registration Department P.O. Box Columbus, GA