11 Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition Module.Total (4) connections.
Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections, shown A.
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with the nut, shown B.
Insert AA battery into ignition module, negative
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
A
(a) 1 2 3
B
Nut
| side | panel |
Left |
| |
|
|
Electronic ignition module
4
(b)
C
+ -
Cap | AA battery |
12
Inside of cart, insert rear tabs(w/o holes) of tank heat shield into slots on the bottom of upper back panel. Attach front tabs(w/holes) of tank heat shield under front brace using two #8x3/8”
Front brace
Tank heat shield
#8x3/8”
20
