Char-Broil 463460712 For Safe Use of Your Grill and to Avoid Serious Injury, Ignitor Lighting

WARNING

For Safe Use of Your Grill and to Avoid Serious Injury:

•Do not let children operate or play near grill.

•Keep grill area clear and free from materials that burn.

•Do not block holes in sides or back of grill.

•Check burner flames regularly.

•Use grill only in well-ventilated space. NEVER use in enclosed space such as carport, garage, porch, covered patio, or under an overhead structure of any kind.

•Do not use charcoal or ceramic briquets in a gas grill. (Unless briquets are supplied with your grill.)

•Do not cover grates with aluminum foil or any other material. This will block burner ventilation and create a potentially dangerous condition resulting in property damage and/or personal injury.

•Use grill at least 3 ft. from any wall or surface. Maintain 10 ft. clearance to objects that can catch fire or sources of ignition such as pilot lights on water heaters, live electrical appliances, etc.

•Apartment Dwellers:

Check with management to learn the requirements and fire codes for using an LP gas grill in your apartment complex. If allowed, use outside on the ground floor with a three (3) foot clearance from walls or rails. Do not use on or under balconies.

•NEVER attempt to light burner with lid closed. A buildup of non-ignited gas inside a closed grill is hazardous.

•Never operate grill with LP cylinder out of correct position specified in assembly instructions.

•Always close LP cylinder valve and remove coupling nut before moving LP cylinder from specified operation position.

Safety Tips

sBefore opening LP cylinder valve, check the coupling nut for tightness.

sWhen grill is not in use, turn off all control knobs and LP cylinder valve.

sNever move grill while in operation or still hot. Uselong-handled barbecue utensils and oven mitts to avoid

burns and splatters.

sMaximum load for sideburner and side shelf is 10 lbs.

greaseThe tray or cup must be installed during use and emptied after each use. Do not remove grease tray or cup until grill has completely cooled.

sClean grill often, preferably after each cookout. If a bristle brush is used to clean any of the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot.

sIf you notice grease or other hot material dripping from grill onto valve, hose or regulator, turn off gas supply at once. Determine the cause, correct it, then clean and inspect valve, hose and regulator before continuing. Perform a leak test.

sKeep ventilation openings in cylinder enclosure (grill cart) free and clear of debris.

sDo not store objects or materials inside the grill cart enclosure that would block the flow of combustion air to the underside of either the control panel or the firebox bowl.

sThe regulator may make a humming or whistling noise during operation. This will not affect safety or use of grill.

sIf you have a grill problem see the "Troubleshooting Section". sIf the regulator frosts, turn off grill and LP cylinder valve

immediately. This indicates a problem with the cylinder and it should not be used on any product. Return to supplier!

CAUTION

•Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety reasons.

•Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and LP cylinder off.

•Do not leave grill unattended while preheating or burning off food residue on HI. If grill has not been regularly cleaned, a grease fire can occur that may damage the product. Follow instructions on General Grill Cleaning and Cleaning The Burner Assembly to prevent grease fires.

Ignitor Lighting

sDo not lean over grill while lighting.

1.Turn OFF gas burner control valves.

2.Turn ON gas at LP cylinder.

3.Open lid during lighting.

4.To ignite, push and turn ignition burner knob to HI.

5. .Push and hold ELECTRONIC IGNITION button until the burner lights.

6.If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure.

7.To ignite remaining burners, turn knob to the HI position starting with the burners closest to IGNITION BURNERS first. If ignitor does not work, follow match lighting instructions.

Lighting instructions are continued on the next page

11