Char-Broil 463460712 manual Storing Your Grill, Cleaning the Burner Assembly

CAUTION

SPIDER ALERT!

SPIDER AND WEBS

INSIDE BURNER TUBE

If you notice that your grill is getting hard to light or that the flame isn’t as strong as it should be, take the time to check and clean the venturi’s.

VALVE

3.	Remove carryover tubes and burners.
4.	Detach electrode from burner.
	NOTE: Removal/Detachment method will depend on the
	burner configuration. See different configurations in
	illustrations below.
5.	Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
	(A) Bend a stiff wire (a light weight coat hanger works well)
	into a small hook. Run the hook through each burner
	tube several times.
	(B) Use a narrow bottle brush with a flexible handle (do not
	use a brass wire brush), run the brush through each
	burner tube several times.
	(C) Wear eye protection: Use an air hose to force air into
	the burner tube and out the burner ports. Check each
	port to make sure air comes out each hole.
6.	Wire brush entire outer surface of burner to remove food
	residue and dirt.
7.	Clean any blocked ports with a stiff wire such as an open

CONTROL PANEL

SPIDER WEBS

INSIDE VENTURI

paper clip.

8. Check burner for damage, due to normal wear and corrosion

BURNER

some holes may become enlarged. If any large cracks or

holes are found replace burner.

VERY IMPORTANT: Burner tubes must reengage valve

In some areas of the country, spiders or small insects have been known to create “flashback” problems. The spiders spin webs, build nests and lay eggs in the grill’s venturi tube(s) obstructing the flow of gas to the burner. The backed-up gas can ignite in the venturi behind the control panel. This is known as a flashback and it can damage your grill and even cause injury.

openings. See illustrations at right.

9.Attach electrode to burner.

10. Carefully replace burners.

11.Attach burners to brackets on firebox.

12.Reposition carryover tubes and attach to burners. Replace flame tamers and cooking grates.

Correct

burner-to-valve

engagement

To prevent flashbacks and ensure good performance the burner and venturi assembly should be removed from the grill and cleaned before use whenever the grill has been idle for an extended period.

Storing Your Grill

• Clean cooking grates.

• Store in dry location.

• When LP cylinder is connected to grill, store outdoors in a well-

ventilated space and out of reach of children.

• Cover grill if stored outdoors. Choose from a variety of grill

covers offered by manufacturers.

• Store grill indoors ONLY if LP cylinder is turned off and

Remove screws

Firebox

be tu Carryover

Firebox

burner Electrode bracket

disconnected, removed from grill and stored outdoors.

• When removing grill from storage, follow “Cleaning the Burner

Assembly” instructions before starting grill.

Cleaning the Burner Assembly

Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.

1.Turn gas OFF at control knobs and LP cylinder.

2.Remove cooking grates and flame tamers.

Firebox

tube

Carryover

Firebox burner bracket

Electrode

Pry off electrode with

a flat blade screwdriver

13