Char-Broil 463741510 manual Burner ,Firebox and Control Knob

Ignitor wire

9

Burner ,Firebox and Control Knob

□Place firebox onto cart. Position the heat shield for tank as shown. Attach with #10-24x1-1/4’’ carriage bolts, 7x15 fiber washers and #10-24 wing nuts ( A).

□Place the heat shield for UFC onto burner venturi tube, then insert burner / heat shield through venturi holes on firebox. Make sure ignitor wire go through th hole on heat shield and firebox as shown (B). Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. Place small end of venturi clip into venturi tube and large part of clip around valve (D). If burner is not leveled from left to right, adjust the two screws attaching valve to control panel in step 8.

□Inside firebox, attach firebox and control panel with 5x15 fiber washers and #8-32x3/8’’ sheet metal screws ( C ).

□Attach ignitor wire to electrode (D).

□ Place control knobs on valves as shown (E). Burner Assembly Heat Shield F/UFC

#10-24x1-1/4’’ Carriage Bolt

7x15 Fiber Washer

#10-24

Wing Nut

B

A

#8-32x3/8’’

Sheet Metal Screw

Qty.2

7x15	5x15
	Fiber Washer
Fiber Washer	Qty.2
Qty.4

	C
	#8-32x3/8’’
Heat Shield F/Tank	Sheet Metal Screw

	#10-24
	Wing Nut		7X15
#10-24x1-1/4’’	Qty.4	Venturi Clip	Fiber Washer
Carriage bolt		Qty.2
Qty.4

Correctly assembled valve in burner tube and venturi clips

E

D

Venturi Clip

Knob

Ignitor Wire

21