Char-Broil 4638232 Ignitor Lighting, Valve Check, Hose Check, Burner Flame Check, Ignitor Check

Typical spider webs inside burner

Ignitor Lighting

￿Do not lean over grill while lighting.

1.Open lid during lighting. Turn on gas at gas source.

2.To ignite any burner, turn burner knob to HI, turn ROTARY IGNITOR button rapidly.

3.If ignition does NOT immediately take place, turn all burner valve knobs to OFF, wait 5 minutes, then repeat lighting procedure.

After Lighting warm up on HI

Match Lighting

￿Do not lean over grill while lighting.

1.	Open lid. Turn on gas at gas source.
2.	Attach match to Match holder, light match.
3.	Push in and turn any burner to HI. Be sure burner
	lights and stays lit. Repeat on other burner.

After Lighting warm up on HI.

Left side of Grill

Match lighting hole

Valve Check

•Important: Make sure gas is OFF at gas source before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly.

Hose Check

•Before each use, check to see if hose is cut or worn. Replace damaged hoses before using grill. Use only valve and hose specified by manufacturer.

CAUTION

Clean burner prior to use after storing, at the beginning of the grilling season or after a period of one

month not being used. Spiders and insects like to build nests in burner tubes

(especially during colder months). These nests can cause fires in

burner tubes or under grill.

See following pages for specific cleaning instructions.

CAUTION

•If burner does not light, turn knobs to OFF. Wait 5 minutes and try again. If the burner does not ignite with valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.

Burner Flame Check	HIGH
• Light burner, rotate knobs	LOW
from HIGH to LOW. You
should see a smaller flame in

LOW position than seen on HIGH. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.

Turning Grill Off

• Turn all knobs to OFF position. Turn gas OFF at gas source.

Ignitor Check

•Turn gas off at gas source. Rotate ignitor button rapidly. "Click" should be heard and spark seen each time between collector box or burner and electrode. See "Troubleshooting" if no click or spark.

General Grill Cleaning

•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush to insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.

•Plastic parts: Wash with warm soapy water and wipe dry. ￿ Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.

•Porcelain grate: Because of glass-like composition, most residue can be wiped away with baking soda/water solution or specially formulated cleaner. Use nonabrasive scouring powder for stubborn stains.

•Stainless Steel: Wash with mild detergent or nonabrasive cleaner and warm soapy water, wipe dry with a soft nonabrasive cloth

4638234 • 13